Before a Large Artwork Goes Up: Six Checks for Boca Raton Walls, Doors and Light

By Hector Morales, Furniture Quality and Practical Buying Specialist at SoBe Furniture

A large artwork can go wrong in ways a small one never does. It can reach the right floor of a condo tower and refuse to turn the corner out of the elevator. It can meet a wall that turns out to be concrete block behind the drywall, after the handyman arrived with drywall anchors. It can land where afternoon sun turns a glossy surface into a mirror, or where a light switch sits exactly where one edge belongs. None of these is a problem with the art. Each is a check nobody made.

In Boca Raton the stakes are higher than in most places. Great rooms are tall and wide, homes are full of glass, the sun is strong all year and the air is humid. In the condo towers of Highland Beach and Fort Lauderdale, a piece 86 inches wide shares an elevator schedule with every other resident, and building rules decide who can drill and when.

This guide covers statement pieces from our Fine Art collection, such as The Thousand Sculptural Wall Art, 86 inches wide and floated off the wall on brass standoffs, and the checks to make before you buy and before anyone drills a hole.

The Thousand sculptural wall art, an 86-inch shaped banknote piece floated on brass standoffs, planned for a large wall in a Boca Raton, South Florida home

The Six Checks That Decide Where a Large Piece Can Hang

Make them in order. The first four decide whether the home can take the piece; the last two decide whether it will keep looking right.

1. Measure the wall and everything on it

Measure the clear wall corner to corner and floor to ceiling, then mark everything that interrupts it: switches, wall sockets, the thermostat, AC grilles, sconces, window casings and the swing of any nearby door. Tape the full outline with painter's tape, 86 by 47 inches for The Thousand, and look at it from the sofa and the front door for a day or two. Tape shows what a tape measure misses, such as a switch plate peeking out beside one edge.

Then do the vertical math, because large pieces run out of height before width. The Maratea Italian Leather Power Reclining Sectional is listed at 29.5 inches high; with an 8-inch gap, The Thousand's 47 inches put its top edge near 84.5 inches, about 11.5 inches below an 8-foot ceiling. Maratea's headrests lift for neck support, so check the clearance with them raised. For width, one 123-inch side of that sectional leaves about 18 inches at each end of an 86-inch piece. Bring those numbers, with the dimensions of the sofa or console below, when you visit the showroom.

2. Find out what the wall is made of

As general advice to confirm with your installer: many South Florida homes have concrete block exterior walls, often with drywall over furring strips, and drywall interior walls over wood or metal studs. Condo towers can add poured concrete. Knocking will not reliably tell you which you have, and the answer changes the hardware: block and concrete take masonry anchors and a hammer drill, while drywall needs studs or anchors rated for the load. A good installer confirms the wall and scans for wiring, plumbing and AC lines before drilling.

In a condo, read the association rules first. Many buildings set work hours and ask for proof of the contractor's insurance, and some restrict drilling into concrete.

3. Get the weight and plan the hardware

Weight decides the hardware, and the hardware is the installer's job. Our art pages do not list weights, so ask our team what is known about the weight and construction of the piece you are considering, and pass it to your installer. The Thousand floats on brass standoffs, which usually means several fixed points, each needing a secure anchor in an exact position, rather than one wire on one hook. Plan on two people to lift anything 86 inches wide, and a laser level: a shaped piece with no frame has no straight edge to judge by eye.

4. Walk the path from the curb to the wall

Large art travels on its edge, so what matters is the shortest side, the depth with packaging and the turns. On edge, The Thousand stands 47 inches tall and clears a standard door, but its 86-inch length must swing through every corner: elevator lobby, corridor, foyer and hall. Measure each opening, and look for tight turns and stair landings.

In a condo, measure the elevator cab inside, plus its door opening. An 86-inch piece may need to stand on end, which takes a cab taller than 86 inches plus packaging, or ride on the diagonal; if the passenger car is too small, ask management about a service elevator. Give us your building contact and we handle the COI, gate pass and elevator reservation for the delivery; allow time for the COI.

5. Study the light and the sun

A high-gloss surface opposite a big window shows the window back to you at certain hours, so photograph the wall in the morning, at midday and late in the afternoon; light from the side is kinder to gloss than light from straight ahead. Then watch for sun on the wall itself, which is hard on any artwork. Through south-facing glass the low winter sun reaches deeper into a room than the summer sun, so a wall shaded in July can take direct sun in January. If the best wall takes sun, our custom window treatments, such as solar shades, are measured at the home and made to each opening.

For heavy texture, plan the light before the hanging. A picture light or an adjustable ceiling spot brings relief forward; a hard-wired fixture needs an electrician and depends on the final height of the art. Aiming ceiling lights at about 30 degrees from vertical is a common rule of thumb for keeping reflections out of your eyes.

6. Check the air: AC and humidity

A good rule, worth confirming with your HVAC contractor: art does best where temperature and humidity stay steady. A large piece covers more wall, so check that no AC supply vent blows straight across it, and keep it off the wall above a cooktop.

What Each Statement Piece Asks of Its Wall

The Thousand: depth, standoffs and a long run of wall

A vintage one-thousand-dollar note enlarged to 86 by 47 inches and sculpted into rippling, wind-swept waves, navy on a glossy ivory ground, cut to the outline of the note and hand-signed by Benzo, a South Florida mixed-media artist. The folds and standoffs give it depth, so ask our team for exact dimensions, including how far it stands off the wall, before choosing a hallway. Only one is available, at $2,999.

Gilded Banquet: a holographic surface that moves

Gilded Banquet Pop Art is 60 by 40 inches, hand-signed by Benzo, with a holographic, raised-gloss surface that shifts with rainbow light as you walk past. That movement is the point, so hang it where people pass, not in a corner seen from one chair. It is also the piece most likely to catch a window, so test the glare at the hours you use the room. $2,799.

Starlit Dance: texture that needs its light

Starlit Dance Textured Canvas, 40 inches wide by 60 inches high and signed by Benzo, shows a dancer in a golden gown beneath a swirling night sky in heavy, sculpted paint. Its own description says the raised paint is best appreciated in person and under a picture light, so check five matters most here. See it at our Boca Raton showroom before you plan that light; call ahead and we will have it ready for you. Being tall, it is also the one for the vertical math over a bed or console. $2,899.

Sonata Violin: a dimensional field for a formal room

Sonata Violin Sculptural Wall Art sets a violin and bow into a glossy, dimensional field of splattered color and butterflies, a vertical piece made to anchor a music room, a living room or a formal entry. Its size is not listed, so ask our team for exact dimensions, including its depth off the wall, before you tape the wall; in an entry that depth meets door swings and shoulders. $4,599.

Condo Tower, Single-Family Home or Seasonal Residence

In a condo in Highland Beach, Delray Beach or Fort Lauderdale, the path and the paperwork come first, and glass walls leave fewer solid ones, so the long wall of an entry or hallway may be the best home for a wide piece. In single-family homes in Boca Bridges, Parkland or Weston, the challenge is scale and height: a double-height great room can take a very large piece, but the installer needs the right ladder or scaffold, and an exterior wall may be block, so have the installer confirm before drilling. In a seasonal home, such as a residence at Royal Palm Yacht & Country Club that stands closed part of the year, schedule delivery and hanging for when someone is there, and confirm the AC plan first.

Delivery and Hanging Are Two Separate Appointments

Our white-glove team delivers across Palm Beach, Broward and Miami-Dade, and delivery is a separate charge: within those counties, the greater of $120 or 3 percent of the merchandise total, per our shipping policy. Hanging and wall mounting are not part of SoBe's delivery, so plan an installer or a handyman who works with large art and with your wall type.

A sequence that works

  1. Choose the wall, tape the outline and photograph it at three times of day.
  2. Have the installer check the wall and hardware, and an electrician rough in any hard-wired picture light.
  3. If the furniture below is also new, let it arrive first and set the art height to the real piece.
  4. Decide where the art will wait after delivery: upright, padded, out of the sun and away from foot traffic, never in a hot garage.
  5. Hang it as soon as the installer can come.

Bring Your Measurements to Our Boca Raton Showroom

Gloss, texture and relief do not read on a screen the way they do in a room. Visit our Boca Raton showroom to see texture, finish and color in person. Call ahead and we will have a specific piece ready for you, since not every piece online is on the floor, and bring your wall and furniture measurements. Or send us a photo of your wall and its measurements through our contact page, and we will help you weigh scale, color and placement alongside your furniture.

SoBe Furniture is at 6599 N Federal Highway in Boca Raton, on the west side of Federal Highway about a mile north of Yamato Road, with free on-site parking. Call (561) 221-6111. We are open seven days a week: Monday through Saturday 10 AM to 7 PM, Sunday 11 AM to 6 PM. For the furniture around a piece, book a complimentary in-showroom design consultation.

Frequently Asked Questions

Does SoBe hang the art it delivers?

No. Our white-glove team delivers across South Florida, but hanging and wall mounting are not part of SoBe's delivery. Plan an installer or a handyman who handles large art.

How do you hang heavy art on a concrete block wall in Florida?

Your installer should confirm the wall first, because drywall over furring strips can hide block behind it. Block and poured concrete generally take masonry anchors set with a hammer drill, with hardware rated for the weight of the piece.

Will an 86-inch artwork fit in my condo elevator?

Measure the cab's inside width, depth and height and its door opening; an 86-inch piece may need to stand on end or ride on the diagonal. Give us the building contact, and we handle the COI, gate pass and elevator reservation for the delivery.

How do I stop glare on glossy wall art near windows?

Photograph the wall at three times of day to see when a window reflects in the surface. Side light is kinder to gloss than light from straight ahead, so a wall beside a window often works better than one facing it. A ceiling spot aimed about 30 degrees from vertical helps keep reflections out of your eyes.

Where can I see large sculptural wall art in Boca Raton?

Visit SoBe Furniture at 6599 N Federal Highway in Boca Raton to see texture, finish and color in person. Call (561) 221-6111 ahead and we will have a specific piece ready for you, because not every piece online is on the floor. The showroom is open seven days a week.

Can I order The Thousand in a different size?

Custom sizes and commissions from the artist are available on request, so ask us to quote another size or commission a new work. Send a photo of your wall with its measurements so the quote starts from the real space.